![]() The dishes and glasses are streaked or have a bluish tinge. The rinse aid has been used up or the dosage is too low.The lid on the salt dispenser is not closed properly.The level of refined salt is low or the dosage setting is not suited to the hardness of the water.The dishes and glasses are covered in a white film or limescale deposits. An excessive amount of foam has been produced: the detergent has not been measured out correctly or it is not suitable for use in dishwashers.The dishes are rattling against each other or against the sprayer arms.The filter is clogged up with food residues.The dishwasher cycle has not yet finished.Strongly push the door until a “clacking" noise is heard. The dishwasher door has not been shut properly.The appliance has not been plugged in properly.Switch off the appliance by pressing the ON/OFF button, switch it back on after approximately one minute and reset the cycle.The dishwasher does not start or cannot be controlled. Turn the appliance off at the ON-OFF button, turn on the water tap and wait approximately 20 seconds before turning the appliance back on the selected wash cycle will start up againĪriston LFF8M122 Dishwasher Troubleshooting Were you to be absent when these beeps are sounded, the appliance will be blocked automatically andindicatorlights2and3 (wash and rinses) will flash rapidly. Turn the tap on and your appliance will start up again after a few minutes. If you have forgotten to turn the water tap on, your appliance will remind you of this by sounding a few short beeps for a few minutes. Your dishwasher is equipped with a safety system which is able to dated any operating anomalies. Is the lid on the salt container dosed properly? Limescale deposits or a white film form on the dishes Is the wash cycle suitable for the dishes you have placed inside the appliance? Have you put the right amount of detergent into the dispenser? Have the instructions on starting the appliance and selecting the desired wash cycle been followed correctly? Is the pressure of the water sup- ply sufficient? Is the water supply tap on and connected to the hose properly? 3 models are not equipped with function of fault codes, so the problems can be identified by description. In solution column there is information of troubleshooting and understanding whether there is a need to call the repairman. Below there are 3 tables, which present possible problems in the operation of equipment. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |